Eppendorf BioSpectrometer Test filter set - Didymium - Manual (Page 3)

Status: 28.02.2011 Trade name: BioSpectrometer Test filter set - Didymium
Product no.: 6135931088-00 Version: 1.0.0 / GB
EC safety data sheet
page 3(4)
Hand protection
Sufficient protection is given wearing suitable protective gloves checked according to i.e. EN 374, in the event of
risk of skin contact with the product . Before use, the protective glove should be tested in any case for its specific
work-station suitability (i.e. mechanical resistance, product compatibility and antistatic properties). Adhere to the
manufacturer
’s instructions and information relating to the use, storage, care and replacement of protective
gloves. Protective gloves shall be replaced immediately when physically damaged or worn. Design operations
thus to avoid permanent use of protective gloves.
Eye protection
Safety glasses recommended
Skin protection
Check suitability of protective clothing for the specific workplace conditions. Chemical resistance of the protective
equipment should be discussed with the manufacturer of the protective equipment.
General protective and hygiene measures
Do not eat, drink or smoke during work time. Keep away from foodstuffs and beverages. Wash hands before
breaks and after work.
9.) Physical and chemical properties
General information
Form cuvette
Colour transparent
Odour odourless
Important health, safety and environmental information
Changes in physical state
Type Boiling point
Value 100 ° C
10.) Stability and reactivity
Conditions to avoid
None known
Materials to avoid
None known.
Hazardous decomposition products
No hazardous decomposition products known.
Thermal decomposition
Remarks No decomposition if used as prescribed.
11.) Toxicological information
Experience in practice
When handled appropriately adverse health effects are not to be expected.
Other information
Product specific toxicological data are not known.
12.) Ecological information
Other information
Ecological data are not available.
13.) Disposal considerations
Product
Allocation of a waste code number, according to the European Waste Catalogue, should be carried out in
agreement with the regional waste disposal company.