Buhler 6000 HQ6095 - Manual (Page 27)

bühler
1500 Bale Carrier
25
6. Bale Deflector Arm Assembly
Remove all hardware that is included with the
deflector assembly.
Remove the two top bolts from outer fork on
lift arm.
Maintain the spacing of the forks if already
preset. If not, set spacing as described in the
fixed pick up arm assembly section.
Insert the coned end of the deflector onto the
end of the outer fork.
Align the bolt holes from the removed bolts
on the outer fork and the end of the deflector
attachment.
Insert hardware supplied with the deflector
the same way the hardware was installed
before the attachment was added.
Torque all hardware according to the bolt
chart and tighten the set screws on the cone
also according to the chart.
During first bale lift, cycle slowly and watch
for excessive flexing or movement of the
deflector. If movement is detected, stop cycle
and retorque all hardware involved.
7. RPU Assembly
Remove lift cylinder and install Pilot Check
assembly (see Appendix B)
Reinstall cylinder at base end only.
Lubricate all pins involved in RPU attachment
with a SAE multi purpose grease.
Align arm to pivots with open end of arm
facing away from the carrier and reinstall pins
with hardware provided and torque to
specifications called for in the bolt chart.
Remove the lift cylinder pin from the RPU
arm.
RPU ATTACHMENT
ASSEMBLY LAYOUT
BALE DEFLECTOR
ATTACHMENT ASSEMBLY
LAYOUT