BenQ ESG-103 - Manual (Page 8)

Chapter 2 Hardware Installation - 4
Chapter 2 Hardware Installation
This chapter will describe how to set up ESG-103 step by step. After you've
set up your ESG-103 well, then you may need to configure your WAN
setting to match the mode that you've applied for from your ISP or NSP.
2.1 Back Panel
2.2 Check the components you need
To set up your ESG-103, you need some components described as below:
(1) 1 x ESG-103 Broadband Router
(2) 1 x Power Adapter
(3) 1 x CAT-5 UTP Fast Ethernet Cable
(4) 1 x ADSL/Cable Modem ( or other broadband device with Ethernet Interface )
(5) 1 x Ethernet Network Card