Lukas LSH 4 - Manual (Page 4)

4
4.7 Aggressive material (acid, lye, solvent, vapour) can damage the machine. It is necessary to
clean the whole machine if it must be exceptionally operated under such conditions or gets into
touch with these materials. Additionally, the machine must be checked as described under 3.6.
5 Safety instructions for hydraulic hoses
All instructions as to safe use of hydraulic hoses can be found in the booklet 84150/8056-85
delivered with the hoses.
6 Application
6.1 General
The hand pump LH 1/0,5 is designed as a two-stage pump which is used for the operation of oil
hydraulic single acting cylinders. It is designed for a maximum system pressure of 700 bar.
Warning
Always check product limitations regarding pressure ratings, load capacities, and set-up
requirements. The system operating pressure must not exceed the pressure rating of the lowest
rated component in the system.
Warning
NEVER set the relief valve to a higher pressure than the maximum rated pressure of the pump.
Higher settings may result in equipment damage and/or personal injury.
7 Applications
The mini cutter with hand pump is meant for cutting in confined spaces or where access is difficult,
e.g. steering-wheel spokes or pedals in vehicles which are severely deformed as a result of an
accident.
In the industrial and trade field, steel rods, screws, etc. can be cut.
8 Connecting the pump
Mini cutter and hand pump are to be connected according to following Scheme:
8.1 Connection of the screw cpouplers
The device is connected to the hydraulic pump with the screw couplers (plug and socket), there
being no risk of mix-up.