Ruvati RVF1228ST - Manual (Page 6)

®
RVF1228ST
www.ruvati.com Printed in USA
1-855-4-RUVATI
Page 5
®
5. Unscrew both screws of the hose
weight until it is in two pieces. Place
one half of the hose weight on the
center sections of the spray hose.
Then place the remaining half of the
weight against the other half and re-
insert the screws. Do not tighten the
screws completely yet (Figure 4).
6. Place rubber gasket A into the
female end of the spray hose pipe
(the longest copper pipe extending
from the faucet’s base). Attach the
spray hose to the spray hose pipe
by screwing in with an adjustable
wrench or pliers.
7. Make sure the spray hose weight is
vertical on the loosest section of the
spray hose and tighten the screws
with a Phillips-head Screwdriver to
secure it into place (Figure 5).
8. Attach the hot and cold water sup-
ply hoses to the faucet by screwing
the male end of each hose with an
adjustable wrench or pliers to each of
the supply hose pipes extending from
the base of the faucet (Figure 6).
Figure 5
Figure 4
Figure 6