Ruvati RVF1215CH - Manual (Page 7)

® ®
RVF1215CH
www.ruvati.com Printed in USA
1-855-4-RUVATI
Page 6
®
Figure 7
Figure 8
Figure 9
9. Then screw the remaining female
ends of the supply hoses to the
corresponding hot and cold water
supply valves using an adjustable
wrench or pliers (Figure 7).
11. Insert rubber gasket B into the
end of the top end of the faucet.
Then attach the faucet head by
screwing until tight (Figure 9). Test
the faucet by turning it on and off.
Make sure there is good water flow
and no leaks. Inspect the faucet
above and below the countertop to
make sure there are no leaks. If there
is a leak, turn the water supply off
and contact Ruvati Support.
10. Turn water supply on (Figure 8).
Turn the faucet on to let water run
through it and flush out any dirt /
debris. Turn faucet off now.