Ruvati RVM4600 - Manual (Page 2)

RVM4600 ®
RUVATI USA
www.ruvati.com
Attention Installer
1. Read these instructions carefully before installation. Inspect sink for damages. Do not
install if the sink is damaged.
2. Ruvati recommends that installation of undermount sinks be done by a professional
installer.
3. Templates are only provided as a guide. Place template on sink to ensure the template
will give you the proper cutout for the sink. Ruvati is not responsible for improper sink
or countertop installation. Ruvati is not liable for any damages to sink or countertop or
personal injury during installation.
4. The instructions in this guide are for installation on a wood countertop. For installation
on granite, marble or cultured stone countertops ask your fabricator for proper
installation instructions. Remind your fabricator to install the sink in a way that it can be
removed in the future from the countertop if necessary.
5. Observe all local plumbing and building codes.
Alignment of sink to cutout is critical for a superior fit and finished look. Depending on
your aesthetic preference, Ruvati sinks can be installed either with a 1/4” reveal, flush fit, or
with a negative reveal. Decide on your prefence prior to installation.
1/4” Reveal
Flush Fit
The countertop edge sits approximately
1/4” back from the edge of the sink and
exposes the rim of the sink.
The countertop meets the edge of the
sink, fitting flush with the sink bowl.
1/4” Overhang
The countertop extends 1/4” over the
edge of the sink on all sides.
Rev 12/11
Printed in USA
Page 2