Warning – Bissell 1699 User Manual

Page 10

Simply choose one of the 3 settings

• High Traffic

•

Normal

• Water Rinse/Carpet Protector

and the ProHeat will adjust the right amount of
cleaning solution to mix with the heated water to
fit your cleaning need.

NOTE: When your cleaning job is finished,
the formula can be stored ready to use in
your machine for the next time!

Set Ready Tools Dial to the Floor Cleaning Setting.

Plug into a proper outlet and turn the Power and
Heater switches to the ON ( I ) position. The
switches are found on the back of the handle.
Allow 1 minute for the built-in heater to warm-up
before cleaning. The ProHeat will be fully warmed
and will provide optimal performance after a
minute of continuous heated cleaning.

The SmartTemp ready light indicates when the
heater is ON ( I ).

Note: SmartTemp heats the cleaning solution
for carpet and bare floor application only. It
does not heat solution sprayed through the
accessory tools.

While pressing the Trigger, make one slow forward
wet pass and another one back. Let the Built-In
Heater, formula, and DirtLifter PowerBrush do the
work for you. Caution: Do not overwet. Take care
not to run over loose objects or edges of area rugs.
Stalling brush may result in premature belt failure.

Release the Trigger and make one slow forward and
backward pass over the same area to remove any
residual dirty water, and aid in drying. Repeat cleaning
passes until solution being pulled up appears clean.
Continue passes without pressing the trigger until you
can’t see any more water being pulled up.

NOTE: Both the SmartMix tank and the
clean water tank must have liquid in them
in order for the machine to spray. If one
tank is empty the machine will not apply
cleaning solution or water.

After cleaning, you may want to turn the SmartMix dial
to Rinse to give your carpeting a final water only rinse.
This will ensure thorough removal of embedded dirt
loosened by the deep cleaning formula. BISSELL deep
cleaning formulas contain an anti-resoiling agent that
helps your carpets repel dirt and keeps them looking
good longer.

Cleaning strokes

Choose The SmartMix Setting

Set Ready Tools Dial

Power Switch

WARNING:

To Reduce the Risk of Fire and
Electric Shock due to internal
component damage, use only
BISSELL cleaning fluids intended
for use with the deep cleaner.

When filling bottle or
storing unit, set

dial to:

HIGH

TRAFFIC

ATER RINSE

CARPET

ROTECT

NORMAL

TOO

PRETREA

FLO

CLEANIN

ReadyTools Dial

SmartMix Dial

Tip:

Deep Cleaning stairs and high traffic areas on

a regular basis can prolong carpet life.

OFF

SmartTemp Light

OFF

Power Switch
SmartTemp Switch

WARNING:

To reduce the risk of fire,
electric shock or injury,
unplug from the outlet
before servicing.

w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1

ug310-5868_1699_306.indd 10

3/1/06 3:13:50 PM