MBW V.E.U. - Manual (Page 9)

- 6 -
M
AINTENANCE
WARNING
Always exercise the stopping procedure before
servicing or lubricating the unit.
After servicing the unit, replace and fasten all
guards, shields, and covers to their original
positions before resuming operation.
CAUTION
Always verify fluid levels and check for leaks after
changing fluids.
Do not drain oil onto ground, into open streams,
or down sewage drains.
Maintenance Schedule
1. Check all hardware after the first 5 hours of use, then follow the maintenance schedule.
2. Calibrate sensor before using VEU. Sensor is NOT calibrated from the factory.
Engine Maintenance
Refer to the engine owner’s manual for maintenance
intervals and procedures.
• Check the engine air cleaner element at least once daily.
• Check the engine oil level by removing the dipstick (the
engine must be level). The oil level should be between
the marks on the dipstick. See the “Check Engine Oil”
section of the engine “Owner’s Manual” for information.
• See the “Change Engine Oil” section of the engine
“Owner’s Manual” for information on the oil change
intervals.
• Disconnect battery for long term storage.
Draining Fuel Tank
Refer to Main Assembly, page 12.
1. Place drain pan under fuel tank.
2. Remove square head pipe plug from bottom of tank.
3. Let tank drain until all water and contaminates are
cleared.
4. Replace plug.
5. Properly dispose of drained fuel.
Engine Speed
Engine speed is factory set according to the speed listed in
the 2850 rpm, page 3 of this manual. Refer to the engine
owners manual for procedure on setting operating speed if
necessary.
Blower Maintenance
The blower contains both a grease lube system and an oil
bath system. Refer to blower manual for service
instructions.
Cleaning Blower Air filter
Refer to Canister and Blower Assembly, page 14.
1. Remove outer knob (# 22) and outer door (#6).
2. Remove inner knob (# 21) and Inner door (# 28).
SYSTEM MAINTENANCE DAILY
EVERY 25
HOURS
EVERY 300
HOURS
YEARLY
Vac air filter Check and clean X
Engine Refer to engine operator/owner manual X
Fuel drain tank X
Hardware Check and tighten as needed
1 X X
In Line Fuel Filter Replace X X
Blower
Refer to Blower operators/owners
manual
X
Gas Sensor Calibrate
2
(Refer to Gas Sensor manual) 4x
Test X