Beko CDA543F User Manual

Page 3

ELECTRICAL REQUIREMENTS

Before you insert the plug into the wall socket make sure that the voltage and the

frequency shown in the rating plate inside the appliance corresponds to your

electricity supply.

Rating label is on the left hand side of fridge inner liner.

We recommend that this appliance is connected to the mains supply via a

suitable switched and fused socket in a readily accessible position.

Should the mains lead of the appliance become damaged or should it need

replacing at any time, it must be replaced by a special purpose made mains lead

which can only be obtained from a BEKO Authorised Service Agent.

WARNING! THIS APPLIANCE MUST BE EARTHED

If the fitted moulded plug is not suitable for your socket, then the plug should be

cut off and an appropriate plug fitted. Destroy the old plug which is cut off as a

plug with bared cord could cause a shock hazard if inserted into a socket

elsewhere in the house.

The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse

need to be replaced an ASTA approved BS 1362 fuse of the same rating must be

used. Do not forget to refit the fuse cover. In the event of losing the fuse cover the

plug must not be used until a replacement fuse cover has been fitted. Colour of

the replacement fuse cover must be the same colour as that visible on the pin face

of the plug. Fuse covers are available from any good electrical store.

IMPORTANT! FITTING A DIFFERENT PLUG

As the colours of the wires in the

mains lead of this appliance may

not correspond with the coloured

markings identifying the terminals

in your plug proceed as follows:

(See diagram).

Connect the green-yellow or

green (Earth) wire to the terminal

in the plug marked 'E' or with

the symbol

or coloured

green and yellow or green.

Connect the blue (Neutral) wire

to the terminal in the plug

marked 'N' or coloured black.

Connect the brown (Live) wire to

the terminal in the plug marked 'L'

or coloured red.

With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or

in the main fuse box.

If in doubt contact a qualified electrician.

FITTED WITH

BS 1362 13A FUSE ALWAYS

FIT BS 1362 REPLACEMENT

CARTRIDGE FUSE

GREEN &

YELLOW

GREEN

BLUE

BLACK

BROWN

RED

22mm.

6mm.

32mm.

12mm.

FUSE

CORD GRIP

TRANSPORTATION INSTRUCTIONS

The appliance should be transported only in a vertical upright position. The

packing as supplied must be intact during transportation.

If during the course of transport the appliance has to be transported

horizontally, it must only be laid on its right hand side when standing in the

front of the appliance. After bringing it to upright position,it must not be operated

for at least 4 hours to allow the system to settle.

Failure to comply with the above instructions could result in damage occuring

to the appliance. The manufacturer will not be held responsible if these

instructions are disregarded.

The appliance must be protected against rain, moisture and other

atmospheric influences.

When positioning your appliance take care not to damage your flooring,

pipes, wall coverings etc. Do not move the appliance by pulling by the door

or handle.

Empty any water in the drain tray before moving. See section ‘Defrosting’ and

‘Care & cleaning’ for further information.

Make sure that the defrost water pipe at the back of the product is fixed to the

plastic evaporating pan on the top of the compressor, to avoid defrost water

spillage on the floor.

IMPORTANT :

Care must be taken while cleaning / carrying the appliance to

avoid touching the bottom of the condenser metal wires at the back of the

appliance as you might injure your fingers and hands.

Do not attempt to sit or stand on top of your appliance as it is not designed for

such use. You could injure yourself or damage the appliance.

"IMPORTANT:

Make sure that mains cable is not caught under the appliance

during and after carrying / moving the appliance, to avoid the mains cable

becoming cut or damaged."

Do not allow children to play with the appliance or tamper with the controls.

BEKO plc declines to accept any liability should the instructions not be

followed.

IMPORTANT

INSTALLATION INSTRUCTIONS

The space in the room where the appliance is installed must not be smaller

than 10 cubic metres.

Do not put your fridge freezer in a cold room where the temperature is likely

to go below +5 degrees C (41 degrees F) during night time and/or especially

in winter.

This fridge freezer has been designed to operate in ambient temperatures

between +5 and +32 degrees C (41 and 90 degrees F) Therefore if the

appliance is installed in an unheated/cold room (eg: conservatory/annex/

shed/garage etc) then the appliance will not operate causing the freezer

compartment to run warmer and as a result the storage time of frozen food

may be reduced.