beautypg.com

Kullanım ve bakım problemleri için çözüm önerileri, 7 cleaning and care, Detergent drawer – Beko D1 7101 EM User Manual

Page 25: The loading door and the drum, Body and control panel, Inlet water filters, 7cleaning and care

background image

TR

25

Detergent drawer

Remove any powder residue buildup in

the drawer. To do this;

1. Press the dotted point on the

siphon in the softener compartment

and pull towards you until the

compartment is removed from the

machine.

C If more than a normal amount of

water and softener mixture starts to

gather in the softener compartment,

the siphon must be cleaned.

2. Wash the dispenser drawer

and the siphon with plenty of

lukewarm water in a washbasin.

Wear protective gloves or use an

appropriate brush to avoid touching

the residues in the drawer when

cleaning.

3. Replace the drawer into its housing

after cleaning. Check if the siphon

is in its original location.

The loading door and the

drum

After each wash:

• Check if there are any foreign

substances in the drum.

• Open the hole in the bellow with the

aid of a toothpick if it is clogged.

C Foreign metal substances in your

machine can cause rust stains. In

such cases:

Clean the drum with a stainless steel

cleaning agent. Never use steel wool

or wire wool.

Body and control panel

When necessary:

• Wipe the exterior panels of your

machine with soapy water or mild

detergent. Dry it with a soft cloth.

• Use only a soft and damp cloth to

clean the control panel.

C Never use a sponge or scrubbing

material. These will damage the

painted and plastic parts.

Inlet water filters

There is a filter at the end of each

water intake valve at the back side of

the machine and also at the end of

each water intake hose where they

are connected to the tap. These filters

prevent the foreign substances and dirt

in the water to enter into the machine.

Filters should be cleaned as they get

dirty.

• Close the taps.

• Remove the nuts of the water intake

hoses to clean the surfaces of the

filters on the water intake valves with

an appropriate brush.

• If the filters are very dirty, you can

pull them out by means of pliers and

clean them.

• Take out the filters on the flat

ends of the water intake hoses

together with the gaskets and clean

thoroughly under streaming water.

• Replace the gaskets and filters

carefully to their places and tighten

the hose nuts by hand.

7

Cleaning and care

This manual is related to the following products: