Apple AirPort Extreme 802.11n (3rd Generation) - Manual (Page 9)

Chapter 1 Getting Started 9
To set up your AirPort Extreme using a Macintosh, you need the following:
Â
A Macintosh computer with an AirPort or AirPort Extreme Card installed to set it up
wirelessly, or a Macintosh computer connected to AirPort Extreme with an Ethernet
cable to set it up using Ethernet
 Mac OS X v10.4 or later
 AirPort Utility 5.4 or later
To set up your AirPort Extreme using a Windows PC, you need the following:
Â
A Windows PC with 300 MHz or higher processor speed and a compatible 802.11a,
802.11b, or 802.11g wireless card, or a wireless card that complies with an IEEE 802.11n
draft specification
 Windows XP Home or Professional (with Service Pack 2 installed) or Windows Vista
 AirPort Utility v5.4 or later
Plugging In AirPort Extreme
Before you plug in your AirPort Extreme, first connect the appropriate cables to the
ports you want to use:
 Connect the Ethernet cable that is connected to your DSL or cable modem (if you will
connect to the Internet) to the Ethernet (WAN) port (< ).
 Connect a USB cable connected from the USB port (d ) on the AirPort Extreme to a
compatible USB printer (if you will print to a USB printer), a hard disk, or a hub.
 Connect an Ethernet cable from any Ethernet device to the Ethernet LAN ports (G ).