Black Box ACU4222A - Manual (Page 35)

SERVSWITCH BRAND USB MICRO EXTENDER FAMILY
34
Audio Interface - Set Up and Operation
The audio interface is line-level and is designed to take the output from a sound card (or other
line-level) source and be connected to a set of powered speakers at the other end of the link.
Stereo audio may be transmitted either way across the link (simultaneously).
No setup is required unless a microphone is connected to the Remote unit.
Connect the extender as follows:
•
Take the line-level output from your sound card (green connector) and connect to ‘Line
In’ on the Local unit.
• Connect ‘Line Out’ on the Remote unit to a set of powered speakers.
Audio Interface – Using a Microphone
A microphone may be plugged into the ‘Line In’ connector on the Remote unit.
There are two ways of setting up a microphone:
•
The Local unit’s ‘Line Out’ connection should normally be wired to the microphone
input (Pink) on your sound card. The sound card should then be set up to provide
additional amplification (+17dB). This is the preferred connection method.
• Alternatively, the Remote unit itself can provide microphone amplification. To set this,
open up the Remote unit and locate the jumper labeled ‘MIC’ on the daughter board.
Connect this jumper across the pins. The Local unit’s ‘Line Out’ connection should then
be wired to ‘Line In’ (Blue) on your sound card.
If your microphone is already amplified, follow the second method but DO NOT install the
amplification jumper in the Remote unit.