Bosch BSH Dishwasher - Manual (Page 10)

10
21"
(533mm)
14"
(355mm)
Figure 19
Hot Water Supply Line
and Electrical Supply
Cable Position in
Channels
DOOR PANEL INSTALLATION
Accessory Panel Installation Kits (select models)
This kit allows you to install a custom panel (up to 1/4”
thick) on your dishwasher. The panel dimensions are
shown in
Figure 16. Install the panel before sliding the
dishwasher into place. Contact Customer Service to see
if a kit is available for your model and to obtain ordering
instructions.
Fully Integrated Models
Fully integrated models allow you to have a custom door
panel made to match your cabinetry. The custom door
can be a two-piece configuration to look like a drawer at
the top and a cabinet door at the bottom or like a single
full-length door. A template is included with the fully
integrated models to explain the mounting procedure.
NOTE: The door springs that are included with the Fully
Integrated units will provide proper function for custom
door panels weighing between 9 and 15 pounds. Custom
Door panels weighing up to 18 pounds require the use of
the Tension Adjustment Screws (See page 14 for details
on the proper use of the Tension Adjustment Screws).
A
B
Figure 16
Door Panel Installation
Fig. 17
Dimension
A
B
27 3/16” - 30 7/16”
(690mm - 774mm)
23 3/16” - 23 3/8”
(589mm - 594mm)
Integrated Panel Dimensions for
Custom Door Panels
25”
(636 mm)
23-1/16”
(586 mm)
1/4” max.
(6 mm)
PLACING THE DISHWASHER
1 Straighten and position the hot water supply line and
the electrical supply cable as shown in Figure 18 so
that they will align with their channels under the
dishwasher base.
2 Position the dishwasher close enough to the
enclosure so that you can run the dishwasher drain
hose to the under sink drain connection. Make certain
that the hot water supply line and the electrical supply
cable are in their channels under the dishwasher
base, as shown in Figure 19.
3 Slide the dishwasher into the opening making sure
that the hot water supply line and the electrical supply
cable stay in their proper channels.
4 Make sure the dishwasher is level. Adjust the rear
leveler by turning the center screw at the front of the
dishwasher, as shown in Figure 20a. Turning the
screw clockwise raises the rear of the dishwasher.
Adjust the front levelers by turning them with a
screwdriver, as shown in Figure 20b. Turning the
levelers to the right raises the dishwasher. If additional
height is needed, shims may be added under the
leveler feet.
Figure 17
Figure 18