Behringer Xenyx XL2400 - Manual (Page 5)

Page 5 of 8
TRIM control
adjusts input gain
80 Hz switch
activates high-
pass filter
12 kHz
shelving
HIGH EQ
HIGH MID EQ is
sweepable from
100 Hz to 8 kHz
LOW MID EQ is
sweepable from
100 Hz to 2 kHz
80 Hz shelving
LOW EQ
EQ switch activates
the equalizer
FX 1 & 2 dials
adjusts volume
signal of channel
to FX unit
PRE switch changes
routing of both effects
paths from “post-
fader” to “pre-fader”
MON 1 & 2 dials
adjusts volume
signal of channel to
monitors
AUX 1 & 2 dials
adjust volume
signal of channel
to AUX sends PAN control sets
position of the
channel signal in
the stereo mix MUTE switch
mutes the
channel
SOLO switch isolates
channel signal in
the headphones
Silky-smooth faders on
all channels and buses
CLIP LED
SIG LED
ROUTING SWITCHES
(1-2, 3-4) assign
channel to a subgroup
MAIN switch routes the
channel signal to the
main mix
HIGH MID control
boosts and cuts
frequencies
centered at 3 kHz
LOW MID control
boosts and cuts
frequencies
centered at 300 Hz
MIC
TRIM
LINE
TRIM
Phantom
Power LED
SOLO LEVEL adjusts
the volume level of all
solo signals routed to
the headphone and
loudspeaker outputs
XENYX XL3200
XL2400/XL1600