Security Chain Co (SCC) Radial Chain LT - Manual (Page 2)

Drive the vehicle one car length
forward. Firmly tighten all connec-
tions. Use the clip on the side cable to
secure the excess cable end. Note; the
inside and outside connection should
not differ by more than one metal bushing.
See the close-up drawing below for a
detailed look at this connection
On the outside of the tire, thread the
cable with bushings through the
end hook for initial mounting. Grasp the
outside side cable with both hands and
pull it towards you. This will create as
much slacks possible. Then make the
outside connection in the same manner.
At the inner sidewall, make the
connection on the inside of the tire
by pushing the cable with the end
bushings behind the tire and toward the
front of the vehicle.
Drape the chain over the tire
so that the smooth side of the
cross member hook is against the tire.
The cross member nearest the end hook
should touch the ground.
Park vehicle on firm level ground,
away from traffic and turn off the
engine. Set the emergency brake. Chains
should be installed on drive tires. Unroll the
chain on the ground next to the tire.
Position the cable so the end hooks are
toward the front of the vehicle.
Installation
Removal
Drive vehicle off highway to safe level ground. Turn off engine and set emergency brake. Stop where the side cable fasteners are
easily accessible (about 5 o’clock position). Release the outside excess side cable from the retaining clips. Unhook the side cable
through the end hook by creating slack in the cable before pushing cable through end hook. Repeat this procedure on inside
fastener. Lay chains on the ground and drive off. Inspect chains for damaged or worn parts. Clean and spray with all-purpose
lubricant. Roll chains up together and place in package.
Close-up of outside fastening system
1 2 3
4 5