Security Chain Co (SCC) Super Z - Manual (Page 3)

For maximum chain life:
*
*
*
*
*
Avoid speeds over 30 mph and use on bare pavement. Traction coils on cross members will fragment and cause
cross members to break. Damage could occur to chains, tires and vehicles.
Ensure rubber tensioners are used at all times.
Avoid spinning tires: start slowly, even in uphill conditions.
Avoid locking brakes: the best braking technique is a pumping action.
If a cross member should break, stop & remove or replace it immediately.
After use, clean and spray with an all-purpose lubricant.
One Year Limited Warranty
This product is warranted free from defect in workmanship and material for one year from the date of delivery to the user.
Defective product may be returned to the manufacturer, freight prepaid, within 10 days of alleged defect. Inspection will
be made to determine cause of failure. Chain determined to be defective will be repaired or replaced. Buyer shall not be
entitled to recover any incidental or consequential damages. No compensation will be made for any labor claim, delays
or damages incurred by using this product. Although this warranty gives you specific rights, you may have other legal
rights which differ from state to state. For more information, please write to:
SCC
Customer Service Dept.
P.O. Box 949
Clackamas, OR 97015-0949
Speeds over 30 mph, improper fit or improper installation voids this warranty.
*
Important:
We strongly recommend that the chains be fitted to the tire prior to actual use to ensure proper fit. Tire sizes may
vary because of age, manufacturer, tread or type.
Shur Grip Z meets SAE Class “S” clearance requirements (15.00mm). Once the chains have been installed, drive a
short distance. If you hear any contact of the chain to any vehicle part, remove chains immediately.
Vehicle manufacturers’ determine the clearance requirements based on the original (OEM) tires provided with the
vehicle. Placing different size tires on your vehicle may affect the clearance necessary to operate this product.
Care should be taken when using this product on wheels or wheel covers that protrude outward beyond the sidewall
of the tire. Wheel covers should be removed to prevent possible markings made by the rubber tensioner. On vehicles
with protruding alloy wheels, other traction products that do not use a rubber tensioner (such as SCC’s Z-Chain or
ladder style cable products) should be used.
During installation of the chain, ensure that the chain drapes at least 2 inches over each side of the tire from the
edge of the tread.
With traction devices installed, the vehicle will handle differently (for example, a longer braking distance on pavement
without snow or ice). Adjust your driving to these changed conditions.
Shur Grip Z is intended for use on snow and ice-covered roads. As such, it is legal in every state and province in
North America, including those where studded tires are prohibited. (Check local laws and regulations for any restrictions
in your area.)