Hornady Lock-N-Load Classic Press - Manual (Page 9)

- 8 - - 9 -
Check case length (for cases to be
crimped) and trim with Hornady
Case Trimmer.
Chamfer inside and debur outside of
case mouth with Hornady Chamfering
and Deburring tool, and wipe case free
of all lubricant with clean dry cloth.
Please Note: Sizing before trimming can
result in Case Mouth not fitting over the
Trimmer Pilot.
Charge prepared cases with
selected powder
and weigh using either a scale, or
powder measure in conjunction with a
scale. Refer to the Hornady Handbook
of Cartridge Reloading or any other
reputable source for proper loads.
Replace the sizing die with
the seating die according to
instructions furnished with the
die set.
Remove the PPS primer arm at this time
to simplify bullet seating. The arm is
slotted and is easily removed by lifting
it up and out of the arm. The opening
in your press is large enough to easily
handle any modern cartridge with no
difficulty.
8
9
10
8
9
10