PureFlow AirDog RP-150 - GM Duramax 2001-2010 - Manual (Page 14)

14
PureFlow AirDog
Raptor
™ 100 & 150 2001-2010 DuraMax Diesel
Section 6 Electrical Harness
DURAMAX RAPTOR
™
WIRING DIAGRAM
Figure 16
Installing the Raptor™ Fuel Pump Wiring Harness.
Figure 28
6-1.
To connect the Power Supply Lead to the Raptor™, insert the 2 pin Deutsch connector on
the end of the wiring harness into the corresponding connector on the Raptor™.
6-2.
Route the wiring harness from the Raptor™ to the fuse/relay panel located under the
hood on the drivers side wheel house .
6-3. Crimp the female spade connector on the end of the Red (+) wire.
Ground Wire
Hot Lead
Water Proof Fuse
Raptor Pump Lead
Figure 29 Figure 30 Figure 31
6-4. Route the Red (+) wire to the fuse panel located under the hood on the driver’s side
wheel house and insert it into a spare fuse holder on the panel that is “hot” when the
starter key is turned to the on position. Secure the wire with plastic ties.
6-5. Connect the Black (-) wire to an adequate ground.
BE SURE TO PROPERLY ROUTE AND SECURE THE WIRING HARNESS TO THE
VEHICLE.