PureFlow AirDog DF-165-4G - GM Duramax 2015+ - Manual (Page 9)

9
PureFlow AirDog
AirDog
®
II-4G 2015 and UP DuraMax Diesel
Section 4 AirDog ® II & Mounting Brackets
Installing the AirDog
®
II & Mounting Bracket on the
Truck’s Frame Jig Bracket!
.
Out to ENGINE FUEL IN
4-1 Install a 1/2” male J2004 quick connect x 3/8”
NPTF (08J2044-3/8NPTF) into the “ENGINE”
and “FUEL IN” ports in the AirDog II.
Figure 7
4-2 Install the 3/8” male J2004 quick connect x 1/8” NPTF (06J2044-1/8NPTF) into the
“TANK” port of the AirDogII. This is the smaller port next to the port marked
“ENGINE”.
Figure 7a
WARNING: The NPT fitting threads must be lubricated with oil or anti-seize compound before
installation to prevent galling!
4-3 Assemble the AirDog II to the formed mounting bracket (part # 001-3C-0004).
4-4. Mark mounting hole locations on frame jig bracket using the mounting bracket (001-3C-
0004) as a template. Or create a paper template from the mounting bracket (001-3C-
0004). Be sure to line the template up as described in order to get the proper clearance
needed when pump is installed.
Figure 9 Figure 10
4-5. After holes are marked drill (4) 3/8” holes for the mounting bolts.
4-6. Attach the completely assembled Airdog to the frame jig bracket.