PureFlow AirDog RP-150 - 6.4L Ford 2008-2010 - Manual (Page 10)

10
Raptor™ 100 & 150
2008 - 2010 Ford PowerStroke
Section 5-A Fuel Lines
Raptor Fuel Line to the Engine.
5A-1. Disconnect the fuel supply line to the engine from the OE fuel pump. This pump is
located on the driver’s side inside frame rail.
Fuel Pump with 1/2” Quick Connect Fitting
To Engine
Figure 5 DISCONNECT HERE Figure 6
View from Front View From Below
5A-2. Insert the female quick connect end (see figure 7) of the
“Pressure Hose Assembly” into the male quick connect fitting
previously installed in the port marked “OUT”. You will hear a
“click” when it connects.
Figure 7
5A-3. Connect the other end of the “Pressure Hose Assembly” (Figure 7a) to
The original factory engine supply line shown in figures 5 & 6. It will “click” when
properly connected.
Figure 7a
5A-4 Any excess fuel hose can be addressed by routing the hose in a fashion to take up the
extra length, or a section of the hose can be removed. Push lock splices have been
included if you choose to remove the excess hose.