L.B. White Sentinel Radiant Tube AT150 Sidewall Mount - Manual (Page 12)

INSTALLING REFLECTORS & SUPPORTS
Refer to Fig. 8 for the following instructions:
1. Attach end cap to non-notched end of a reflector. Use
4 U-clips.
2. Slide the reflector through the hangers until end cap
is up against burner box.
3. Slide remaining reflectors over tubes. Overlap the
reflectors 2-3 inches. Non-notched ends overlap
notched ends.
4. Attach remaining end cap to last reflector with U-clips.
5. Install a support at end of reflector nearest burner
box,and at middle and ends of all reflectors. Do not
install a support directly next to a hanger on the same
reflector.
FIG. 8
12