L.B. White 250 Norseman - Manual (Page 9)

8
BURNER AND GAS CONTROL ASSEMBLY
1. Remove hex bolt from underside of burner. See Fig. 1.
2. Position pre-assembled burner and gas control into
case assembly of heater:
a. Burner head is located between tabs in base.
b. Burner mounting hole in base aligns with tapped
hole in burner casting.
3. Fasten burner to base using bolt removed in step 1.
Tighten securely.
FIG. 1
BURNER MOUNTING BOLT
TABS
1/4" DIA HOLE MOUNTING HOLE
HOSE AND REGULATOR ASSEMBLY
1. Always use approved pipe thread compound suitable
for use with L.P. gas or natural gas on the threaded
connections.
2. Assemble the components together according to Fig.
2. This view is to show general assembly of the
components only.
3. Tighten all connections securely.
4. Check aall cconnections ffor ggas lleaks uusing aapproved
gas lleak ddetectors.
HOSE
REGULATOR
PROPANE GAS SUPPLY
CONTAINER VALVE
TO
HEA
TER
FIG. 2