Steele Products SP-GM655 - Manual (Page 5)

WARNING
Do not under any circumstances place hands inside the feeding chutes while the machine is in
operation. Force feeding of debris is not necessary due to the natural suction of the machine.
OVERLOAD PROTECTION AND MOTOR JAMMING
If over feeding clogs the machine the overload protection switch may cut out the motor. To restart,
first switch the machine off and disconnect the power cord.
Unscrew the 3 Top Hopper assembly knobs and remove the Top Hopper assembly to remove any
clogged debris from the cutting chamber.
If the top cover assembly becomes jammed and will not lift off, turn the V-cutter by pushing a piece
of wood through the back chute of the Top Hopper to rotate the V-Cutter to enable the top cover
assembly to be removed.
Reset the motor overload protection switch. Fig. 14.
8
IMPORTANT:
Before replacing top cover assembly ensure that the V-cutter is positioned as shown in Fig. 15.
Replace the top cover assembly together with the three (3) Top Hopper assembly knobs ensuring
they are tight.
9
Parts List