Steele Products SP-PT235 - Manual (Page 5)

OWNER’S MANUAL
4
TECHNICAL SPECIFICATIONS
Technical Specifications
Drill Model#
Input Voltage
120V~60Hz
Input Power 4.2 Amp
No Load Speed 0 - 3000 RPM
Chuck Capacity 3/8" (10mm)
Power Cord 18AWG
Double Insulated Yes
SERVICE
NOTE: ONLY QUALIFIED PROFESSIONAL ELECTRICANS SHOULD ATTEMPT
TO REPAIR OR REPLACE ANY PARTS TO THIS TOOL.
T ool service, mechanical and/or electrical is to be performed only by qualified repair
personnel. Service performed by unqualified personnel may result in a risk of injury.
When servicing a tool, use only identical replacement parts. Use of unauthorized parts or
failure to follow maintenance instructions may create a risk of electrical shock or injury.
OPERATION
WARNING!
Never touch the drill bit or other tool while it is moving.
Do not touch the drill bit after operation, it will be very hot.
If the drill bit jams in the work piece or if the drill stalls, stop immediately. Remove the bit
from the work piece and correct the reason for stall before continuing.
Turn the tool off immediately and do not operate, if tool speed drops abnormally low,
begins to make abnormal noise, vibrations, or if the motor housing produces smoke or
burning odor.
SYMBOLS
The following symbols are used for the tool:
V ..................... Volts
Amp................. Amperes
~......................Alternating Current
.................... Double Insulted
HZ ................... Hertz
RPM ................ Revolutions Per Minute