Steele Products SP-PT221 - Manual (Page 5)

4
When servicing a tool, use only identical replacement parts. Follow
instructions in the maintenance section of this manual. Use of
unauthorized parts or failure to follow maintenance instructions may
create a risk of electric shock or injury.
Assembly:
Your palm sander comes fully assembled. You only need to install the
sandpaper before operation.
1) Make sure that the tool is unplugged and the switch is in the
OFF-POSITION.
2) Then make sure that the plastic base is free of dust and dirt.
3) Stick hook & loop sand paper to the sander. Make sure it is aligned
properly.
Operation
• Make certain that the work subject is secured firmly and the sander
is not in contact with the work-piece or table.
Start the tool before placing it onto the work-piece this will reduce deep
scratching in the surface of the work piece.
• Before plug in the tool, make sure that the switch is in the OFF-position.
• To turn on the tool, press the On/Off switch to the “ON” position.
• To turn off the tool, press the On/Off switch to the “OFF” position.
ON/OFF Switch
Dust Bag
Connection
Hook & Loop
Sand Paper