Off Road Unlimited 79003 Defender Series 99-Current Ford Super Duty Rear Bumper Guard - Manual (Page 3)

ORU - Ford Super Duty Rear Bumper Guard
offroadunlimited.com
page 2
photo 1 photo 2
photo 3
1) Starting with the drivers side, remove the 2 nuts that attach the factory bumper bracket to the frame
and install the left support bracket with the factory nuts (See photo #1). Do not fully tighten at this time.
Repeat on passenger side of vehicle.
2) Have an assistant hold the bumper guard in place and loosely attach to support brackets with 3/8”
bolts, washers, and lock nuts. Attach guard to factory safety chain holes using
1 /
2
” bolts, flat washers,
and lock nuts (See photos #2 & 3). Do not fully tighten at this time.
3) Adjust bumper and guard positions and tighten bolts to factory specifications.
4) Install plastic end caps.