Off Road Unlimited 70230-H Dana 44 Axle Crossover Steering System - Manual (Page 3)

ORU- Dana 60 Axle Crossover Steering System
Bill of Materials, P/N 70230-H
Grade 8 nut torque specifications
5/16" nuts 20 ft. lbs. M6 nuts 9 ft. lbs.
3/8" nuts 35 ft. lbs. M8 nuts 23 ft. lbs.
7/16" nuts 60 ft. lbs. M10 nuts 45 ft. lbs.
1/2" nuts 75 ft. lbs. M12 nuts 75 ft. lbs.
9/16" nuts 160 ft. lbs. M14 nuts 120 ft. lbs.
5/8" nuts 175 ft. lbs. M16 nuts 165 ft. lbs.
INSTALLATION NOTES:
• Inspect the contents of the kit and read the entire instructions before proceeding.
• We recommend this installation be performed by a qualified technician.
• Torque all hardware to factory specifications.
• We recommend using red Loctite on all bolts.
• When removing wheels, support vehicle with jack stands.
• Prior to proceeding, check to see that you have the proper knuckle for your application.
Check the factory tie rod nut position to verify either “nut-up” or “nut-down” style.
Steering Knuckle-
1) Set the parking brake. Block the rear wheels. Raise front of vehicle and support with jack
stands.
2) Remove the passenger side front wheel.
3) Unbolt brake caliper and support out of the way (do not allow caliper to hang by brake line!).
4) Remove the factory hub assembly.
5) Remove the brake rotor (this is a good time to inspect / re-pack the wheel bearings & seals).
6) Remove the factory spindle (inspect / grease inner spindle bearing).
offroadunlimited.com
page 2
ORU- Dana 44 Axle Crossover Steering System