Off Road Unlimited 70010 Ford Reverse Shackle Kit for 86Ѕ-91 F-350 4X4 - Manual (Page 5)

ORU - Ford F-350 Shackle Reversal Kit
offroadunlimited.com
page 4
24) Hold bumper bracket up to front of frame and mark lines where new cross member is located.
Cut bumper bracket at marked line (see photo 8). Re-install bumper using remaining hole.
Align bumper. Mark, center punch, and drill second mounting hole. Use factory hardware in
new mounting hole.
25) Install tires, raise front of vehicle and remove jack stands, place vehicle back on ground.
Torque spring and shackle bolts and wheels to specifications.
26) Remove trac arm from lower bracket. (Back of axle housing, passenger side) Loosen
upper track bar bolt (do not remove). Place (2)
3 /
8
” spacers on top of the factory trac arm
bracket at top of the axle housing. Line up spacers with factory holes and leave in position.
Install new bracket on lower end of trac arm, while it is hanging, using provided 9/16” bolt.
Bring bracket and trac arm into position. Using factory hardware, install through track arm
bracket and sleeve. Torque bolts at this time. Drill out remaining holes in front of bracket
and install
3 /
8
” x 7 /
8
” bolts (see photo 9).
27) Install lengthened sway bar links and straighten steering wheel.
photo 1 photo 2 photo 3