Off Road Unlimited 60093-A,B,C Torsion Sway Bar - Manual (Page 3)

INSTALLATION NOTES:
This kit requires the (2) factory sway bar frame mounting clamps, bushings, and hardware. If you
do not have these items, you will need to obtain them prior to installation.
• Inspect the contents of the kit and read the entire instructions before proceeding.
• We recommend this installation be performed by a qualified technician.
• Torque all hardware to factory specifications.
• We recommend using red Loctite on all bolts.
• When removing wheels, support vehicle with jack stands.
INSTALLATION
1) Slide factory rubber bushings onto sway bar, position bar centered in factory clamps, and attach
to frame (see diagram 1).
2) Slide locking collars onto sway bar until they contact bushings and tighten lock screws.
3) Attach torsion arms to sway bar with arc pointing down (see diagram 2). Be sure arms are both
indexed the same.
4) Assemble end links and attach at sway bar and spring u-bolt plate tabs.
5) Check all clearances and tighten all hardware to specifications.
ORU - GM IFS Kit Torsion Sway Bar
offroadunlimited.com
page 2