Off Road Unlimited 60036-D Dana 44 Axle Crossover Steering System - Manual (Page 2)

ORU- Dana 44 Axle Crossover Steering System
Bill of Materials, P/N 60036-C&D
Part#
Qty. Description
60036-C Kit, (Knuckle Only, Dana 44 or 10-bolt, 6-8" lift w/tie rod facing "nut-up"):
60036-C 1
Knuckle (nut-up)
60036-D Kit (Knuckle Only, Dana 44, 6-8" lift w/tie rod facing "nut-down"):
60036-D 1
Knuckle (nut-down)
Grade 8 nut torque specifications
5/16" nuts 20 ft. lbs. M6 nuts 9 ft. lbs.
3/8" nuts 35 ft. lbs. M8 nuts 23 ft. lbs.
7/16" nuts 60 ft. lbs. M10 nuts 45 ft. lbs.
1/2" nuts 75 ft. lbs. M12 nuts 75 ft. lbs.
9/16" nuts 160 ft. lbs. M14 nuts 120 ft. lbs.
5/8" nuts 175 ft. lbs. M16 nuts 165 ft. lbs.
INSTALLATION NOTES:
• Inspect the contents of the kit and read the entire instructions before proceeding.
• We recommend this installation be performed by a qualified technician.
• Torque all hardware to factory specifications.
• We recommend using red Loctite on all bolts.
• When removing wheels, support vehicle with jack stands.
• NOTE: To use these kits, you must convert your steering box to a
two-wheel drive unit from the same year!!!!!
• Prior to proceeding, check to see that you have the proper knuckle for your application.
Check the factory tie rod nut position to verify either “nut-up” or “nut-down” style.
offroadunlimited.com
page 1