Bakers Pride Classic-Line Proofer Heater CPH70-MP17 - Manual (Page 11)

11
Problem: Probable Cause: Solution:
Unit will not run (heater
and fan are off)
Power cord is not plugged in Plug in power cord
Circuit breaker is tripped Call a licensed electrician
No power at outlet Call a licensed electrician
Defective power cord or switch Call a licensed service agency or a
licensed electrician
Compartment too cold Check door Instruct user to keep door closed
Poor door seal Check door seal and replace if necessary
Thermostat setting is too low Turn thermostat knob to a warmer
position. This should be done one
increment at a time until a satisfactory
temperature is obtained
Defective thermostat Check thermostat. If necessary, call a
licensed service agency or a licensed
electrician
Compartment too hot Thermostat setting is too high Turn thermostat knob to a cooler position.
This should be done one increment at a
time until a satisfactory temperature is
obtained
Defective thermostat Check thermostat. If necessary, call a
licensed service agency or a licensed
electrician
No humidity No water in pan Add hot water
Selector Switch on heat Switch to Proof Mode
Humidity thermostat set too low Adjust thermostat (usually 1/4 to 1/3 of full
range)
TROUBLESHOOTING
! ! DANGER: The following work is to be performed only by a licensed electrician. There is hazardous
voltage which can shock, burn or kill. Turn power off. Unplug power cord before service or cleaning.