Digital tuner, Programming tuner stations, Fm am – Philips AZ1155 User Manual
Page 12
English
Manual tuning:
• Gently turn the ROTARY
NAVIGATION ring to
5 or 6 , and
then release.
• Repeat the above until you reach the
desired frequency.
To improve reception
• For FM, pull out the telescopic antenna.
Incline and turn the antenna. Reduce its
length if the signal is too strong (very close
to a transmitter).
➜ Display shows stereo if FM station is
received in stereo.
• For AM the set is provided with a built-in
antenna so the telescopic antenna is not
needed. Direct the antenna by turning the
whole set.
5 To switch off the tuner, press POWER.
Programming tuner stations
Store up to 30 tuner stations in the
memory, manually or automatically.You can
also erase a preset station by storing
another frequency in its place.
Autostore
Automatic programming will start with a
chosen preset number. From this preset
number upwards, former programmed
tuner stations will be replaced.The unit will
only program stations which are not in the
memory already.
1 Press ALBUM, PRESET + or - once or
more (
¡ or ™ on the remote control) to
select the preset number where
programming should start.
Note: If no preset number is selected, default
is preset 1 and all your presets will be
replaced.
2 Press PROGRAM for more than 2
seconds to activate programming.
➜ Display shows 'A' (autostore) and
'Sr ch' and available stations are
programmed in order of waveband : FM,
followed by AM.The last preset
automatically stored will then be played.
C
D
M
O
D
E
P
R
O
G
R
A
M
ULTRA
BASS 2 • DIGI
TAL
TU
NE
R
OP
EN
• C
LO
S
E
A
LB
U
M
P
R
E
S
E
T
A
LB
U
M
P
R
E
S
E
T
FM
AM
12
AZ 1150 /17
page
12
Digital Tuner
AZ1150/17 eng 30/5/01 14:53 Page 12