Philips SRU4105-27 User Manual

Page 7

Setting ALL Volume/Mute Controls to Any
Mode

You can set all modes to “punch-through” to any mode
for Volume/Mute control without needing to change to
that mode by doing the following.

1. Press and hold SETUP until the indicator remains on,

then release SETUP.

2. Press and hold MUTE until the indicator blinks off,

then release the button.

3. Press and release SELECT to select the desired

mode (TV, VCR, etc.) for Volume/Mute control; the
indicator blinks, then stays on.

4. Press and release MUTE; the indicator turns off.

Note: The indicator will blink rapidly for 3 seconds if
the mode you have selected does not have Volume/
Mute control.

5. All other modes will now “punch-through” to your

chosen mode for Volume/Mute control.

Setting Any Mode to Use its Own Volume/
Mute Control

You can set any mode to use only its own Volume/Mute
control.

Note: If your chosen mode does not have Volume/Mute
functions, then this remote’s VOLUME and MUTE will
not operate.

1. Press and hold SETUP until the indicator remains on,

then release SETUP.

2. Press and hold MUTE until the indicator blinks off,

then release the button.

3. Press and release SELECT to select the desired

mode (TV, VCR, etc.); the indicator blinks, then
stays on.

4. Press and release VOLUME- (down); the indicator

blinks, then stays on.

5. Press and release MUTE; the indicator turns off.
6. All modes will now “punch-through” to the

respective modes you have chosen for Volume/
Mute control.

Setup (cont.)

Programming Combo Device Codes

Some combo (combination) devices (TV/VCR, TV/DVD,
DVD/VCR, etc.) require you to set up 2 different modes
to control both parts of the combo.

For example, if you have a TV/DVD combo, you might
need to set up one code under the TV mode to control
the TV and a separate code (under other modes) to
control the DVD.

VCR/DVD/DVR Punch-Through Feature

This remote allows the 6 VCR buttons (PLAY, PAUSE,
STOP, SCAN+, SCAN-, and REC) to “punch-through”
(transmit or hand-over) control from any mode pro-
grammed with TV or Cable codes to the last VCR, DVD,
or DVR mode used.

For example, if you have 2 DVD, VCR, or DVR devices
programmed into this remote, the last device you used
controls the 6 VCR buttons.

Note: This feature will not operate if the programmed
TV, SAT or Cable code has its own VCR transport
button control e.g. a TV Combo, SAT/PVR, etc.

Volume/Mute Control and Punch-Through
Feature

Your

remote

allows you to select which device mode

controls VOLUME and MUTE.

This remote is initially set for all device modes to use
their own Volume/Mute control if present.

If the programmed code does not have Volume/Mute
operation, then VOLUME and MUTE will “punch-
through” (hand-over) control to the TV-mode device
without you needing to change to TV mode.

Note: Any

mode chosen for Volume/Mute control must have its
own Volume/Mute function or else VOLUME and MUTE
will not function.

Setup