Philips SRU5100-27 User Manual

Page 6

Code Identification Feature

The Code Identification Feature allows you to identify
the three digit library code stored under your device key.
For example, if you want to find out what three digit
code is stored under your TV device key, follow the six
steps below:
1. Press and hold the CODE SEARCH button until the

red indicator stays on. Release the CODE SEARCH
button.

2. Press and release the desired mode button (TV,

VCR, etc.). The red indicator blinks, then stays lit.

3. Press and release the CODE SEARCH button. The

red indicator blinks off.

4. To find the first digit for the code stored under the

mode key pressed in step 2, press each numeric key
from 0-9 in turn. When the red indicator blinks off
the number you pressed is the first digit for the code
you are searching for.

5. To find the second digit, repeat step 4, this time

when the red indicator blinks off this is the second
digit.

6. Repeat step 4 again to find the third digit.

Sleep Timer

The SLEEP button operates the Sleep function of your
device providing it supports the Sleep function.
Alternatively, you can enable the remote to turn off
your TV after a period of 1 to 99 minutes as shown
below. This feature is only available for the TV Mode
and the remote must be in TV Mode to set a Sleep
Timer. This feature works even if your TV does not
have its own Sleep function.

1. Press and release the TV Mode button.
2. Press and hold the CODE SEARCH button until the

red indicator stays on. Release the CODE SEARCH
button.

3. Press and release the SLEEP button (Note any

previously set Sleep timer is cancelled at this point
and the remote returns to normal operation).

4. Press and release the numeric buttons (01-99) for

the time required. The red indicator blinks off to
indicate button press acceptance and remains off
after the second button press.

5. TV Sleep Timer now set.
6. Leave the Remote pointing towards the TV with an

unobstructed path.

To cancel the Sleep Timer, press and release the
POWER button in TV Mode or repeat Steps 1, 2 and 3
above.

Most users will store VCR codes under the VCR button,
Cable codes under CABLE, etc. If (for example) you
want to store a VCR code under CABLE, first follow the
procedure for Direct Code Entry (previous page) and
press CABLE in step 2 of Direct Code Entry, then enter
ANY VCR code in step 3 of Direct Code Entry. Then
follow the steps above for Code Search (or Brand
Search, below). Note: If the device does not have a
CHANNEL UP button, use PLAY (VCR only) or
POWER instead. Code Search starts from the currently
stored three digit number under that mode.

Code Search, cont.

Code Search by Brand

Lets you search for a code for a specific Brand within
the Code Library for a particular manufacturer.

1. Turn on the device (TV, VCR, etc.) to be controlled.
2. Press and hold the CODE SEARCH button until the

red indicator remains on, then release CODE
SEARCH button.

3. Press and quickly release the desired mode button

(TV, VCR, etc.). The red indicator blinks off once.

4. Press and release the numeric button (0-9)

corresponding to desired Manufacturer (see table on
code list sheet). The red indicator blinks off once.
Note, pressing “0” performs a full library search same
as normal Code Search Method on previous page.

5. Press the CHANNEL UP button ((or POWER or

PLAY (VCR only)) repeatedly until the device to be
controlled changes channel. The red indicator blinks
off with each button press. If you accidentally
overshoot the code required, press the CHANNEL
DOWN button to backtrack through the library until
the device changes channel. Pressing CHANNEL
UP changes direction to forward again.

6. Press and release MUTE to install the code.

Brand Search Method entry is now complete.
Note: When all codes under a Brand have been searched
the red indicator flashes rapidly for 3 seconds.