Breville BSB600 User Manual

Page 5

When depressing the ‘ON’ button the blender will
operate at the speed selected by the variable
speed control, while using the BOOST button will
always results in maximum speed operation. The
BOOST button can be used at any time.

Note

To detach the stainless steel
blending shaft

Ensure the switch is released, power is turned off
at power point and the appliance is unplugged.
Hold the motor body with one hand, and using thumb
and finger, press on the two EJECT buttons on either
side of the motor body (Fig 4) whilst holding the
blending shaft in the other hand. Pull the motor
body away from the blending shaft to detach.

The Wizz Stick Professional has a Variable Speed
Control. To decrease speed turn the dial anti-
clockwise and to increase speed turn the dial
clockwise (See Fig 5).

Note

The Wizz Stick Professional motor will only operate
while the ON or BOOST buttons remain depressed –
this is a safety feature.

Wizz Stick Professional Hand Blender – assembly & operation

To attach the stainless steel
blending shaft

Hold the shaft with the blades down, and align the top
end of the blending shaft with the corresponding end
of the motor body and push until the blending shaft
‘clicks’ and locks onto the motor body (See Fig 1).
Always ensure blending shaft is dry, and no water
left inside, before reattaching.

To use the hand blender

Ensure the blender is completely and properly
assembled as detailed above.
1. Place food to be processed into the jug provided

(or a sufficiently large mixing bowl or saucepan).
The jug provided should be only

⁄

full or less

when blending liquids or when making a puree
of fruit and/or vegetables (See Fig 2).

2. For food preparation tips and recipes refer to

page 18 and the recipes section.

3. Insert the plug into a 230/240V power outlet

and turn the power on.

4. By turning the dial at the top of motor body,

select a speed between MIN and MAX on the
Variable Speed Control.

5. Place the blending shaft as deeply as possible

into the jug and depress the ‘ON’ button to turn
the blender on. The button must be kept
depressed for the required duration of operation.

6. If extra turbo power is required when blending,

press the BOOST button.

7. Work through the ingredients in the jug with a

gentle raising and lowering motion.

8. Switch off the motor by releasing the ‘ON’ button.
9. Ensure the motor has completely stopped before

lifting the blender out of the jug.

10. When processing has finished, switch off at the

power outlet and remove the power plug.

THE PROCESSING BLADE ON THE BLENDING SHAFT IS EXTREMELY SHARP, KEEP FINGERS AWAY
FROM THE BLADES AT ALL TIMES.