Philips HTL2101-F7 - Manual (Page 9)

10 EN
Equalizer
Change the high frequency (treble) and low
frequency (bass) settings of the SoundBar.
1
Press TREBLE +/- or BASS +/- to change
the frequency.
• Press RESET to reset your treble/
bass level to the default settings
programmed at the factory.
» All Source indicators on the main unit
blink twice when treble or bass is set
to the maximum or minimum value.
MP3 player
Connect your MP3 player to play your audio
files or music.
What you need
• An MP3 player.
• A 3.5mm stereo audio cable.
1
Using the 3.5mm stereo audio cable,
connect the MP3 player to the AUDIO-IN
connector on your SoundBar.
2
Press AUDIO-IN.
3
Press the buttons on the MP3 player to
select and play audio files or music.
USB storage devices
Enjoy audio on a USB storage device, such as an
MP3 player and USB flash memory, etc.
What you need
• A USB storage device that is formatted
for FAT file systems, and complies with the
Mass Storage Class.
• An MP3 or WMA file on a USB storage
device
1
Connect a USB storage device to the
SoundBar.
2
Press USB on the remote control.
» The play starts after a few seconds.
Note
• This product may not be compatible with certain types
of USB storage device.
• If you use a USB extension cable, USB HUB, or USB
multi-reader, the USB storage device may not be
recognized.
• Digital camera PTP protocols are not supported.
• Do not remove the USB storage device while it is
being read.
• DRM-protected music files (MP3, WMA) are not
supported.
• Support a USB port: 5V , 500mA.
Apply factory settings
You can reset your SoundBar to the default
settings programmed at the factory.
1
In mute mode, quickly press AUX twice.
» The factory settings is restored.
HTL2101_F7_UM_V2.0.indb 10 2013/5/27 14:17:12