Blaupunkt BERGAMO RCR 148 - Manual (Page 14)

35
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Recalling stored stations
You can recall any stored station at the touch
of a button.
•
Select the memory bank with FM T or
BND.
• Press the corresponding preset button
briefly to recall the station.
Scanning stored stations with
Preset Scan
You can have all of the stored stations briefly
scanned on all wavebands.
Preset Scan cannot be started unless PTY
has been switched off (“PTY” is not lit up in
the display).
•
If necessary, press PTY.
To start Preset Scan:
•
Press SC for approximately 1 seconds.
All of the stored stations on the selected
waveband will be scanned one after the oth-
er. In the display “SCAN” will alternate with
the flashing station name or frequency.
To select a scanned station and switch
off Preset Scan:
•
Press SC briefly.
Note:
If “TA” shows on the display panel, the sys-
tem will scan the stored traffic stations only.
Scanning stations with Radio-
Scan
You can briefly scan through all of the re-
ceivable stations of the selected waveband.
To start the Scan function:
•
Press SC briefly.
The scanned frequency or station name will
flash in the display. During the actual scan-
ning process “FM SCAN” or “AM SCAN” will
be displayed.
To select a scanned station and switch
off Radio-Scan:
•
Press SC briefly.
If no station is selected, the scan function
will be automatically switched off after the
frequency band has been run through com-
pletely. The unit will tune in the station lis-
tened to before starting the scan.
Selecting the seek tuning sensi-
tivity
You can alter the automatic seek tuning
sensitivity.
If “lo” is displayed, the radio will only pick up
strong, local stations.
If “lo” does not light up, the radio will also
pick up weaker, distant stations.
To switch the seek tuning sensitivity:
•
Press lo briefly.
Notice:
Should you tune in a station which has al-
ready been stored before, then the corre-
sponding preset position and memory bank
will briefly flash in the display.
Automatically storing the
strongest stations with Travel-
store
You can automatically store the six most
powerful FM stations of your current recep-
tion area sorted according to their signal
strength. This function is particularly conven-
ient on longer trips.
•
Press the FM T or BND button for
1 sec.
“T-STORE” will appear in the display.
The six strongest FM stations will be auto-
matically stored on the memory bank “T”
(Travelstore). When this process has been
completed, the radio will play the first sta-
tion stored on preset 1.
If desired, stations can also be stored man-
ually on the Travelstore bank (see “Storing
stations”).
Ber/Mon/WiRCR148 gb 08.05.2002, 11:42 Uhr 35