Philips MC-M570-37 - Manual (Page 20)

20
English
3139 115 22181
Programming the disc tracks
Programming tracks is possible when playback is
stopped. Up to 99 tracks can be stored in the
memory in any order.
IMPORTANT!
It is only possible to program from the
current selected disc tray.
DISC 1
DISC 5
DISC 1
DISC 2
DISC 3
DISC 4
1
2
3
5
4
DISC 2 DISC 3 DISC 4 DISC 5
CD / CD-R / CD-RW COMPATIBLE
5 D I S C D I R E C T P L AY
OPEN/ CLOSE
DISC 5
DISC 2
DISC 3
DISC 4 3
POWER ON/OFF
DISC 1
2
4
6
7
3 5 ,
1
1
Load the desired discs on the disc trays (refer
to “Loading discs”).
2
Press CD or one of the DISC 1~5 buttons
to select a disc.
3
Press PROGRAM (PROG) to start
programming.
➜
PROG starts flashing.
4
Press í or ë repeatedly to select the
desired track.
● For MP3 disc, press а / б ( ALBUM 43)
and н / л ( TITLE -+) to select the
desired album and title for programming.
5
Press PROGRAM (PROG) to store.
● Repeat steps 4–5 to select other tracks.
➜ If you attempt to program more than 99
tracks, " PROGRAM FULL" is displayed.
6
To start program play, press ÉÅ.
7
To stop playback or to end the programming,
press Ç once.
➜
PROG stays and the program mode remains
active.
Notes:
– If the total playing time reached 100 minutes or
if one of the programmed tracks has a number
greater than 30, then "
-- : --" is displayed instead
of the total playing time.
– The system will exit programming mode if no
button is pressed within 20 seconds.
Checking the program
1
Stop playback and press í or ë repeatedly.
2
Press Ç to exit.
OR
Press ÉÅ to star t playback from the
current programmed track
Clearing the program
● Stop playback, then press Ç to clear the
program.
OR
Press the OPEN/CLOSE
0 button of the
disc tray.
➜
PROG disappears and " PROGRAM CLEARED"
is displayed.
Note:
– The program will be erased if the system is
disconnected from the power supply or you switch
to other source mode.
Disc Operations