Philips SPS6010A-17 - Manual (Page 5)

5
2 Insert one A23 battery with correct polarity
(+/-) as indicated.
3 Close the battery compartment.
Control your devices
The plugged devices can be turned on or off
easily by the remote control. You can control
each plugged device individually or control all
the plugged devices at the same time.
Note
• The remote controlled range (open field) is up to 40
feet.
• The output rating of each receiver is 125V/13A.
• Press button A to turn on/off the outlet of
Receiver A.
• Press button B to turn on/off the outlet of
Receiver B.
• Press button C to turn on/off the outlet of
Receiver C.
• Press button ALL ON/ALL OFF to turn
on/off all the outlets of the three receivers
at the same time.
Tip
• If you want to purchase more than one unit, make sure
that they have two different frequencies (1 and 2) as
indicated by stickers on the back side of packaging. You
can also find the stickers in the battery compartment
of remote control and on the surface close to mains
plug of the receivers. The remote control of this unit
operates on either Channel 1 or Channel 2 frequency.
3 Get started
Note
• To avoid any potential hazard, use the power source supplied
by your local authorities.
There are three receivers and one remote
control. You can control up to three receivers
with the remote control.
1 Plug the receivers into a properly grounded
outlet.
2 Plug your devices into the AC outlet of
receivers.
Install/Replace remote control
battery
Caution
• Risk of explosion! Keep the battery away from heat,
sunshine or fire. Never discard the battery in fire.
• Risk of product damage! When the remote control is
not used for long periods, remove the battery.
For first-time use:
Remove the protective tab to activate the
remote control battery.
To replace remote control battery:
1 Open the battery compartment.
English
EN