Philips TS3258C - Manual (Page 22)

SLEEP POWER
AV STATUS/EXIT CC TV/VCR-CLOCK TV
VCR
ACC
VCR INCREDIBLE A/CH
UP
SMART
SOUND
SMART
PICTURE
MENU SURF
VOL CH
MUTE
MULTI
MEDIA STEREO RECORD
24
4
ANT "A"
75
L
AUDIO
R/MONO
IN-2 IN-1 OUT
VIDEO
S-VIDEO
AV 1
AV 2
SVID-R
1
3
2
AUDIO OUT
R L S-VIDEO
OUT
ANT/CABLE
OUT
The S(uper)-Video connection on
the rear of the television can give
you better picture detail and
clarity, for the playback of S-
VHS VCR tapes, or Digital Video
Discs than the normal antenna
picture connections.
Note: The VCR (or Digital Video
Disc player) must have a S-
VIDEO OUT(put) jack in order
for you to complete the connec-
tions shown on this page.
Connect the S-VIDEO
CABLE to the S-VIDEO input
jack on the rear of the television,
then the AUDIO (red and white)
to the AUDIO IN (IN 2) jacks on
the rear of the TV.
Connect the S-VIDEO
CABLE to the S-VIDEO output
jack on the accessory device.
Then connect the red and white
AUDIO CABLES to the AUDIO
(left and right) output jacks on
the rear of the accessory device.
Turn the VCR (or Digital
Video Disc Player) ON.
Press the AV button on the
remote to tune to the SVID-R
channel. You are now ready to
view the tape or disc on the TV.
AUDIO IN
(RED/WHITE)
VIDEO IN
(YELLOW)
H
OW TO
U
SE THE
A
UDIO
/V
IDEO
I
NPUT
J
ACKS
BEGIN
S-VIDEO CABLE
(NOT SUPPLIED)
DSS, DVD, Video Game, etc.
(EQUIPPED WITH S-VIDEO AND
AUDIO OUTPUT JACKS)
BACK OF ACCESSORY
S-V IDEO I NPUT
BACK OF TV
NOTE: Repeatedly pressing the AV
button on the remote will toggle the
picture source from the current chan-
nel (Tuner A or B), to the SVID-R
connection, to the AV 1 connection,
to the AV 2 connection.
This also applies to the Multi Media
button on the remote. Repeatedly
pressing the Multi Media button will
toggle the picture source from the
current channel (Tuner A or B), to
the MM 1 (SVID-R) connection, to
the MM 2 (AV 1) connection, to the
MM 3 (AV 2) connection.
IF YOU ARE USING A
MONO DEVICE, USE
ONLY THE AUDIO
R/MONO JACK.
S MART H ELP
The S-VIDEO and
VIDEO IN-2 Inputs are in
parallel. The S-VIDEO input is
dominate when in use. If seperate
video signals are connected to the
S-Video and the VIDEO IN-2
Inputs, the signal from the VIDEO
IN-2 input will be unuseable.
If you have added SVID-R to the
TV’s channels memory, just press
the CHANNEL + or – buttons to
select the S-VIDEO mode.