Braun 760cc-3 Series 7 - Manual (Page 25)

25
w On/off switch
e
«sensitive» setting button
r «intensive» setting button
t
Reset button
z Shaver display
u Shaver-to-station contacts
i
Shaver power socket
o Travel case
p Special cord set
Before shaving
Prior to fi rst use you must connect the shaver to
an electrical outlet using the special cord set
p
or alternatively proceed as below.
Installing the Clean&Renew station
• Using the special cord set
p
, connect the
station power socket 6 to an electrical outlet.
• Press the lift button
2
to open the housing.
• Hold the cleaning cartridge
7
down on a fl at,
stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge into the base of the station
as far as it will go.
• Slowly close the housing by pushing it down
until it locks.
The cleaning fl uid display 1 will show how much
fl uid is in the cartridge:
«high» up to 30 cleaning cycles available
«low» up to 7 cleaning cycles remaining
«empty» new cartridge required
Charging and cleaning the shaver
Insert the shaver head down into the cleaning
station. (The contacts
u
on the back of the
shaver will align with the contacts 3 in the
cleaning station).
If required, the Clean&Renew station will auto-
matically charge the shaver. The hygiene status
of the shaver will also be analyzed and one of
the following cleaning program indicators
5 will
light up:
clean
fast clean
high
clean
low
empty
cl ea n & dry
fast clean
high
clean
low
empty
c le an & dry
fast cle an
high
clean
low
empty
c lea n & dry
2
1
new
clean
fast clean
high
clean
low
empty
cl ea n & dry
fast clean
high
clean
low
empty
c le an & dry
fast cle an
high
clean
low
empty
c lea n & dry
2
1
new
high
low
empty
high
low
empty
high
low
empty
high
low
empty
high
low
empty
high
low
empty
high
clean
low
empty
cl ea n & dry
trim
m er
rese t
Series 7
high
clean
low
empty
cl ea n & dry
trim
m er
rese t
Series 7
98901176_765cc_Japan.indd 25 98901176_765cc_Japan.indd 25 12.05.2009 11:23:46 Uhr 12.05.2009 11:23:46 Uhr