Philips FW-C777-37 - Manual (Page 21)

21
English
To interrupt playback
● Press ÉÅ.
➜ To resume normal playback, repeat the
above.
To stop playback
● Press Ç.
➜ If the system remains in stop mode for 30
minutes, it will switch to Eco Power standby
mode.
Repeat and Shuffle
You can select and change the various play
modes before or during playback.
Repeat play
1
Press REPEAT on the remote repeatedly to
select :
A
B
C D
E
A – to repeat playback of the current track.
B – to repeat playback of the current disc.
C – to repeat playback of all available discs.
D – to repeat playback of the current
programmed track (only if the program
mode is active)
E – to repeat playback of all the programmed
tracks (only if the program mode is active)
2
To resume normal playback, press REPEAT
until "
OFF" is displayed.
Random play
● Press SHUFFLE on the remote to turn
on / off the shuffling mode.
➜ If activated,
SHUF
is shown and the repeat
mode (if any) will be cancelled.
➜ All the available discs or programmed tracks
(if program is active) will be played in random
order.
Note:
– Pressing the OPEN • CLOSE button will cancel all
repeat and shuffling modes.
Programming the disc tracks
Programming tracks is possible when playback is
stopped. Up to 40 tracks can be stored in the
memory in any order.
DISC 1 DISC 1
DISC 2 DISC 2
DISC 3 DISC 3
DISC 4 DISC 4
DISC DISC 3 DISC DISC 4 DISC DISC 5 DISC DISC 2 DISC DISC 1 CD CD /CD-R CD -R /CD-RW CD -RW COMP CO M PATIBLE TIBLE
DISC 1 DISC 1
3
4
6
7
2 5 ,
1
1
Load the desired discs on the disc trays (refer
to “Loading discs”).
2
Press PROGRAM (PROG) to start
programming.
➜
PROG starts flashing.
3
Press CD or one of the CD 1~5 buttons to
select a disc.
4
Press í or ë repeatedly to select the
desired track.
5
Press PROGRAM (PROG) to store.
● Repeat steps 3–5 to select other discs and
store the tracks.
➜ Skip step 3 if you are selecting tracks from
the same disc.
➜ If you attempt to program more than 40
tracks, "
PROGRAM FULL" is displayed.
6
To start program play, press ÉÅ.
7
To stop playback or to end the programming,
press Ç once.
➜
PROG
stays and the program mode remains
active.
Notes:
– If the total playing time reached 100 minutes or
if one of the programmed tracks has a number
greater than 30, then "
--:--" is displayed instead
of the total playing time.
– The system will exit programming mode if no
button is pressed within 20 seconds.
Disc Operations