Philips AJ7030DG-37 - Manual (Page 15)

15 EN
6 Other features
Set alarm timer
Set alarm
In standby mode, you can set two alarms to ring
at different time.
Note
• Make sure that you have set the clock correctly.
1
Press and hold AL1/AL2 for two seconds
to activate alarm setting mode.
» The hour digits and alarm icon begin
to blink.
2
Press TUNING +/- or / to set the
hour.
3
Press AL1/AL2 to confirm.
» The minute digits begin to blink.
4
Repeat steps 2 to 3 to set the minute and
alarm volume.
Select alarm source
Adjust AL1/2 iPhone·RADIO·BUZZ control to
select alarm source for both alarms.
Note
• When alarm time comes, the selected radio, buzzer, or
iPod/iPhone turns on.
•
You can only select the same alarm source for Alarm
1/ Alarm2.
• If iPhone is selected as alarm source, while no iPhone/
iPod is connected, the clock radio switches to buzzer
source instead.
Activate/deactivate alarm timer
1
Press AL1/AL2 to view alarm settings.
2
Press AL1/AL2 again to activate or
deactivate the alarm timer.
» or is displayed if alarm timer is
on and disappears if it is off.
To stop the ringing alarm:
Press the corresponding AL1/AL2.
» The alarm repeats ringing for the next
day.
Snooze alarm
When alarm sounds, press SNOOZE.
» The alarm snoozes and repeats ringing
9 minutes later.
To adjust alarm interval (in minutes), press
SNOOZE repeatedly.
Set sleep timer
This clock radio can switch to standby mode
automatically after a preset period.
Press SLEEP repeatedly to select the sleep
timer period (in minutes).
» When the sleep timer is activated,
appears.
To deactivate the sleep timer, press SLEEP
repeatedly until [OFF] (off) appears.
15 30 60 90 120
OFF