Philips SPS1020P-17 - Manual

EN ES
Specifications
Transmitter Receiver
Frequency 315MHz
Receiving distance 50 ft in open area (The number may be variable according
to the environment and battery condition.)
Transmitter power input DC 12V alkaline battery (size 23A)
Receiver power input AC 125V electrical outlet
Receiver power output 13 Amps / 125 Volts Resistive
13 Amps / 125 Volts General purpose
1000W Tungsten
Federal Communication Commission
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference; and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Notice for the USA
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Relocate the receiving antenna.
• Increase the separation between equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications made to this device that are not expressly
approved by Philips Consumer Lifestyle may void the user’s authority to operate
the equipment.
Installation
1. Mount the receiver on the wall near a grounded electrical outlet. The
nail or screw head must be extended at least 3/16” out from the wall.
2. Hang the receiver onto the nail or screw from the slot located at the
back of the receiver.
3. Plug the power cord of the receiver into the outlet. Then plug the
device cord into the receptacle at the bottom of the receiver.
4. Pull out the battery isolated film under the transmitter.
Operation
1. Press ON on the transmitter to turn the receiver on.
2. Press OFF on the transmitter to turn the receiver off.
Outdoor remote control
SPS1020P