BMW 325XI - Manual (Page 112)

112
To remove cargo cover and
partition net
1. Press the buttons on the sides – see
arrow 1
2. Extract the case by pulling to the rear
– see arrow 2.
Installation
Simply slide the case forward in the two
side holders until it engages.
Storing with backrests folded
forward
Supports for the case are provided on
the rear sides of the backrests – see
arrow 1.
Insert the case from the right as shown
in the illustration, continuing until the
detent engages – see arrow 2. Ensure
that the cargo cover points toward the
front of the vehicle, with the partition
net's loop on the top.
You can pull the partition net out and
insert it into the holders above it in the
upper roof area.
To ensure that the case is properly
positioned, remember to insert it
on both guides from the right side,
always continuing until the detents
snap into place. Failure to observe the
prescribed insertion procedure could
also result in damage to the door's
upholstery.
<
Cargo area
Online Edition for Part-No. 01 41 0 157 605 - © 09/03 BMW AG