Philips Wireless Rear Audio module RWSS9512 - Manual (Page 5)

6 EN
Connect rear speakers to
wireless receiver
Note
• The rear speakers in the picture showed may vary.
Connect the rear left and rear right speakers
to the matching connectors at the back of the
wireless receiver.
Connect power cord
Warning
• Risk of product damage! Ensure that the power supply
voltage corresponds to the voltage printed on the back
or the underside of the product.
Connect the power cords for home theater,
wireless receiver and other devices after you
have made all of the other connections.
» The wireless indicator lights and the
wireless receiver is ready to use.
REAR
LEFT
REAR LEFT REAR RIGHT
~AC MAINS
REAR
RIGHT
3 Troubleshooting
Follow these steps if:
• there is no sound from the rear speakers,
and
• the indicator on the wireless receiver blinks
continuously for more than one minute.
1
Connect the home theater, wireless
transmitter, and wireless receiver correctly
(see 'Connect' on page 5).
2
Insert a pin into the pairing pinhole at the
back of the wireless receiver.
» The indicator on the wireless receiver
blinks for thirty seconds. Complete the
remaining steps within thirty seconds.
3
Switch the home theater to either AUX
source or MUSIC iLINK source.
4
Press and hold the Navigation button
(right) until PAIRING (PAIRING) blinks on
the home theater display panel.
» 'PAIRED (PAIRED) is displayed.
• If FAILED (FAILED) is displayed, repeat
steps 1 to 4.
RWSS9512_00_UM_V1.0.indb 6 2012/7/30 9:47:04