Philips Universal remote control SRU4007 Big button User Manual

Page 10

Troubleshooting

Remote does not operate your product.

• Press the mode button of the product you want to

control.

• Program the remote with a new code.
• Install new batteries. (You might have to reprogram

your remote after installing new batteries.)

• Remote may not be compatible with your product.

Remote does not operate some features of your product.

• Program remote with a new code.
• Remote may not be able to operate all features of

your product or button names might be different
than your product.

Red Indicator blinks after you program a product code.

• Remote did not accept the code.
• Try to program the code again or try a different

code.

For help with setup, please call: 919-573-7854.

The manufacturer warrants that this product shall be free
from defects in material, workmanship and assembly,
under normal use, in accordance with the specifications
and warnings, for as long as you own this product. This
warranty extends only to the original purchaser of the
product, and is nontransferable. Defective products,
together with the dated proof of purchase, must be
returned to the place of purchase for repair or
replacement. THERE ARE NO OTHER EXPRESS
WARRANTIES. Incidental and consequential damages
are disclaimed where permitted by law. This warranty
gives you specific legal rights, and you may also have
other rights which vary from state to state.

Made in China. Quality Assured in USA.
Ledgewood, NJ 07852

Limited Lifetime Warranty

To Clear all Learned Commands under a mode

Clearing learned commands is helpful if, for example, you
replace your CD player with another brand or model. If
you had learned a feature from your old CD player’s
original remote on to this remote (such as RANDOM
PLAY), that feature would no longer work for your new
CD player. Should you wish to remove or clear one or
more “learned” commands, follow the steps below:

1. Press and hold the SETUP button until the red

indicator turns on. Release the SETUP button.

2. Press and release the button for the mode you want

to clear (TV, VCR, etc.). The red indicator blinks off.

3. Press and release the LEARN button TWICE. The

red indicator blinks off.

4. Press and release the SETUP button. The red

indicator turns off. All learned Commands under that
mode are now cleared.

Master Clear - To Clear all Learned
Commands under all modes

1. Press and hold the SETUP button until the red

indicator turns on. Release the SETUP button.

2. Press and release the LEARN button TWICE. The

red indicator blinks off.

3. Press and release the SETUP button. The red

indicator turns off. All Learned commands in the
remote are now cleared.

Clearing Commands