Bissell Powerforce Turbo bagless 6585 series - Manual (Page 10)

10
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
M
aintenance and care
Replacing the HEPA post-motor filter
Use only BISSELL Style 12 HEPA filter (#3205) in
your BISSELL PowerForce Turbo Bagless.
1. Unplug the cleaner from electrical outlet.
2. The HEPA post-motor filter assists in the filtra-
tion process to return clean air to the room. It
is located behind the door on the front of the
cleaner. When the filter becomes dirty, open
the door, remove the filter and replace.
Note: This filter is not washable and must be
replaced.
3. Replace the door by inserting the tabs on the left
side and snapping the right side into place.
Maintaining TurboBrush
The TurboBrush should be checked regularly for clogs
or debris wrapping around the brush roll.
1. Remove tool from hose or front of vacuum.
2. Twist collar so opening is at the top and lift top
cover to remove.
3. Remove the brush from the belt and clean debris.
4. Replace the brush inside the belt and place
ends into slots on sides.
5. Reposition top cover making sure to line up
inside tab at the front with the opening on the
cover. Twist collar until opening is at the bot-
tom to lock into place.
WARNING:
To reduce the risk of
injury from moving parts,
turn off vacuum cleaner
and disconnect Power
Plug from electrical outlet.
HEPA
Post-Motor
Filter
ug110_4018_6585_1207.indd 10 ug110_4018_6585_1207.indd 10 12/19/07 10:04:57 AM 12/19/07 10:04:57 AM