beautypg.com

Using your sonicare, Brushing instructions, Clean and white mode brushing instructions – Philips HX6733-90 User Manual

Page 6: Brushing modes

background image

Note: To keep the battery fully charged, you may

keep your Sonicare on the charger when not in use. It

takes 24 hours to fully charge the battery.

Using your Sonicare

Brushing instructions

1

Wet the bristles and apply a small amount of

toothpaste.

Place the toothbrush bristles against the teeth

at a slight angle towards the gumline.

Press the power on/off button to turn on the

Sonicare.

Apply light pressure to maximize Sonicare’s

effectiveness and let the Sonicare toothbrush

do the brushing for you.

5

Gently move the brush head slowly across

the teeth in a small back and forth motion

so the longer bristles reach between your

teeth. Continue this motion throughout

your brushing cycle.

Note: To make sure you brush evenly throughout the

mouth, divide your mouth into 4 sections using the

Quadpacer feature (see chapter ‘Features’).

6

Begin brushing in section 1 (outside top teeth)

and brush for 0 seconds before moving to

section (inside top teeth). Continue brushing

in section (outside bottom teeth) and brush

for 0 seconds before moving to section

(inside bottom teeth).

EngliSH

10

After you have completed the brushing

cycle, you can spend additional time brushing

the chewing surfaces of your teeth and areas

where staining occurs. You may also brush your

tongue, with the toothbrush turned on or off,

as you prefer.

Your Sonicare is safe to use on:

Braces (brush heads wear out sooner when used

on braces)

Dental restorations (fillings, crowns, veneers)

Note: The toothbrush may be turned off at any time

by pressing and holding the power on/off button for 2

seconds.
Clean and White mode brushing

instructions

The Clean and White mode combines 2 minutes

of Clean mode for a whole mouth clean, with an

additional 30 seconds of White mode to focus on

the visible front teeth.

1

Brush the first 2 minutes as instructed in steps

1-6 above.

After the minutes of Clean mode, the

White mode begins with a change in brushing

sound and motion. That is your signal to start

brushing the upper front teeth for 15 seconds

At the next beep and pause, move to the

bottom front teeth for the final 15 seconds of

brushing.

Brushing modes
Sonicare automatically starts in the default Clean

mode. To select a different brushing mode:

-

-

EngliSH

11